AED 15.75
1
Description
Ambient light sensor simulation module light intensity visible light sensors
TEMT6000 highest sensitivity sensor is 570nm, which has a wide ± 60 ° angle of half sensitivity. Although the device is very sensitive to ambient light, it can inhibit the infrared (IR) spectrum, which can provide a similar " eye " of the spectral response of greater visibility.
Using TEMT6000 Phototransistor Ambient Light Sensor for Arduino
Using TEMT6000 Phototransistor Ambient Light Sensor for Arduino
his code reads the voltage of common Collector configuration and displays the voltage in Volts.
/*
* This is Arduino Sketch for TEMT6000 Phototransistor Module
* This code reads the voltage of common Collector configuration
* and displays the voltage in Volts.
* V pin is connected to 5V
* G pin is connected to ground GND
* S pin is signal connected to A0 of Arduino
*
Written by Ahmad Shamshiri for Robojax.com
* on May 10, 2018 at 14:14 at Ajax, Ontario, Canada
* This code is provided at http://robojax.com
* Watch Video instruction for this code:https://youtu.be/pxR6e-3XkIk
*/
#define light A0 // define input pin
void setup() {
// TEMT6000 Roboajx.com code
Serial.begin(9600);
}
void loop() {
// TEMT6000 Roboajx.com code
int Lvalue = analogRead(light);// read the light
int mVolt = map(Lvalue,0, 1023, 0, 5000);// map analogue reading to 5000mV
float volt =(double)mVolt/1000;// convert millivolt to volt
Serial.print(mVolt);// print millivolt
Serial.print( "mV ");
Serial.print(volt,3);// print volts with 3 decimal places
Serial.println( "V ");
delay(1000);// wait for 1000 milliseconds
// TEMT6000 Roboajx.com code
}